Magnavox MDR533H owner manual Channel Setting, Auto Channel Scan

CHANNEL SETTING

Auto Channel Scan

If you have changed antenna connection, we recommend that you program available channels in your area with the following procedures.

1	Press [MENU] and use [K/ L] to select
	“General Setting”, then press [OK].
	“General Setting” menu will appear.
2	Use [K/ L] to select “Channel”, then
	press [OK].
	“Channel” menu will appear.
	Use [K/ L] to select “Auto Channel
3 Preset”, then press [OK].
4	Use [K/ L] to select the type of
	broadcasting signal, then press [OK].
	Auto Channel Preset
		Antenna
		Cable (Analog)
		Cable (Analog / Digital)
	The unit will start getting channels available in
	your area.
	• When using Antenna, Cable Box, or Satellite
		Receiver with the RF Coaxial cable, you would
		scan with the “Antenna”.
	• When connected to Cable TV, select “Cable
		(Analog)” or “Cable (Analog / Digital)”.
	To cancel the auto channel preset during
	scanning:
	Press [RETURN] to go the previous screen or
	[MENU] to cancel.
	When scanning is over, press [MENU]
5 to exit.

Introduction Connections Basic Setup Recording Playback

Editing

To cycle through only the memorized channels, use [CHANNEL /].

To select a channel directly (including the ones not memorized), use [the Number buttons] and [ • ] (for digital TV channels).

Note

•If Auto Scan is cancelled during the scanning, some channels will not be programmed.

Function Setup Others

Español

EN 29