Aiwa CA-DW539 DUBBING A TAPE, MICROPHONE MIXING, Maintenance, 6 Press c on deck, with the side to be recorded facing out, 2 Insert a tape to be recorded on into deck

with the side to be recorded facing out.

The power is turned on.

c is pressed simultaneously.

The HIGH-SPEED DUBBING indicator lights up: Dubs at high speed.

The HIGH-SPEED DUBBING indicator goes off: Dubs at normal speed.

a on deck 1 is released and recording starts.

To stop recording, press Z on deck 1 and deck 2. The power will be automatically turned off.

NOTE

When recording near a television, noise may be recorded. Move the unit away from the television.

To prevent accidental erasure

Break off the plastic tabs on the cassette tape with a screwdriver or other pointed tool after recording.

To record on the tape again

Cover the tab openings with adhesive tape, etc.

Side A

Tab for side A

Connect a microphone with a mini plug to the MIC jack and play a source to be mixed.

To record the microphone mixing sound, insert a tape in deck 1 and press w.

•During dubbing at high speed, the microphone mixing sound is not recorded.

MIC VOL – Adjusts the microphone volume. If a howling sound is produced, turn the volume down.

•To prevent howling, hold the microphone away from the speakers. The use of unidirectional type microphones is also recommended.

To clean the cabinet

Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.

To clean the heads

When the tape heads are dirty;

- high frequency sound is not emitted - the sound is not adequately high

-	the sound is off-balance	En
-	the tape cannot be erased	En

- the tape cannot be recorded on

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Use separately sold dry-type or wet-type cleaning cassette.

Refer to the instructions of the cleaning cassette for details.

ENGLISH 11