A RADIO OPERATION

1 Press RADIO BAND * repeatedly to select the desired band.

FM AM

The power is turned on and the previously tuned station is received.

*or BAND on the remote control (applicable when the AC cord is connected)

2 Press f, g (TUNING -, +) to select a station.

During FM stereo reception, is displayed.

After listening, press POWER 6 STANDBY/ON to turn the power off.

For better reception

FM

AM

REPEAT/MODE/SLEEP *

- If an FM stereo broadcast contains noise, press the

button so that is displayed.

Noise is reduced, although reception is monaural. To restore stereo reception, press the button again.

- If a high-pitched sound is heard during AM recording, press the button repeatedly to display “b1” or “b2”, so as to eliminate the noise.

* or MODE on the remote control

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/ step. If you use the unit in an area where the frequency allocation system is 9 kHz/step, change the interval as follows.

1Press RADIO BAND.

2Press POWER 6 STANDBY/ON while pressing

RADIO BAND.

When the AM tuning interval is changed, the preset stations are cleared.

Extend the rod antenna

The antenna is inside the

and orient it for the best

unit. Position the unit for

reception.

the best reception.

For quick tuning (Auto Search)

Keep f, g pressed until the tuner starts searching for a station. When a station is tuned to, the search stops.

If the broadcast signal is weak, it does not stop. To stop the search manually, press f or g.

To listen with the headphones

Connect headphones with a stereo mini plug to the

\PHONES jack on the rear of the unit.

6ENGLISH

NOTE

If the unit picks up noise from other electrical appliances nearby, like a TV or fluorescent lights, move the unit.

Page 6
Image 6
Aiwa CSD-FD99, CSD-FD88 manual Radio Operation, Press Radio Band * repeatedly to select the desired band