Power Supply
6STANDBY OPE/BATT
The 6STANDBY OPE/BATT indicator lights up while electric current flows to the unit.
Using on AC House Current
Connect the AC cord as illustrated below.
| to the AC inlet of the unit |
supplied AC cord | to an AC outlet |
| |
| (AC 230 V, 50 Hz) |
Specifications
Tuner section
Frequency range, antenna — FM: 87.5 - 108.0 MHz Rod antenna,
MW: 531/530 - 1,602/1,710 kHz (9/10 kHz step) Ferrite bar antenna,
LW: 153 - 288 kHz Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels / Frequency range — Normal tape: 50 - 12,500 Hz (EIAJ) / Recording system — AC bias / Erasing system — Magnet erase / Heads — Recording/playback head (1), Erasure head (1)
CD player section
Disc — Compact disc / Scanning method —
General
Speaker — 100 mm cone type (2) / Output — Headphones jack (stereo
1.9W + 1.9 W (DIN 1% Rated Power) / Power requirements — DC 12 V using eight size C (R14) batteries, AC 230 V, 50 Hz / Power
consumption — 16 W
Dimensions (W × H × D) — 435 × 184 × 277 mm Weight (excluding batteries) — 3.7 kg Accessory — AC cord (1)
•Specifications and external appearance are subject to change without notice.
•Specifications, trade mark, model name and the double square symbol
are marked on the bottom of the unit.
COPYRIGHT
Please check the copyright laws relating to recordings from disc, radio or external tape for the country in which the machine is being used.
CAUTION
Use only the supplied AC cord. Use with other cords may result in the risk of fire.
Using on Batteries
Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, with the 0 and 9marks correctly aligned. Then close the lid.
To switch from AC power supply to battery power supply, disconnect the AC cord from the AC inlet.
R14 (C)
When to replace the batteries
The 6STANDBY OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, or sound is distorted during operation.
Notes on batteries
•Do not mix different types of batteries or old batteries with new ones.
•When the unit is not to be used for a long period, remove the batteries to prevent needless battery wear.
•Never recharge the batteries, apply heat to them or take them apart.
•Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Unless otherwise noted, the illustration in the Operating Instructions shows the
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.
To clean the heads
When the tape heads are dirty;
-high frequency sound is not emitted
-the sound is not adequately high
-the sound is
-the tape cannot be erased
-the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a head cleaning cassette.
Use separately sold
Refer to the instructions of the cleaning cassette for details.
Lens
To clean the lens
Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge.
ENGLISH 3