You can manually tune in and store the radio frequency of the desired stations.
1 Press TUNER BAND (or FUNCTION repeatedly) to switch the function to tuner.
2 Press TUNER BAND repeatedly until the desired band appears in the display.
The bands you can receive vary depending on the model you purchased.
Be sure to check which bands you can receive.
Every time you press the button, the band changes cyclically as follows:
2 band model: FM y AM
3 band model: FM t MW t SW
3 Press TUNING MODE repeatedly until “AUTO” and “PRESET” disappear from the display.
4 Press – or + (or turn TUNING operation dial on the unit) repeatedly to tune in the desired station.
5 Press TUNER MEMORY.
A preset number appears.
6 Press – or + (or turn TUNING operation dial on the unit) repeatedly to select the desired preset number.
7 Press ENTER.8 Repeat steps 2 through 7 to store other stations.
Other Operations
To | Do this |
Tune in a station | Follow the procedure described |
with a weak signal | |
| |
|
|
Set another station | Start over from step 2. After |
to the existing | step 5, press – or + (or turn |
preset number | TUNING operation dial on the |
| unit) repeatedly to select the |
| preset number you want to store |
| the other station. |
|
|
The AM tuning interval is
9kHz (or 10 kHz for some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding TUNING MODE on the unit, press ?/1 on the unit. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in Power Saving Mode (page 25).
Tips
•The preset stations are retained for about a day even if you disconnect the power cord or if a power failure occurs.
•To improve broadcast reception, adjust the supplied antennas, or connect a commercially available external antenna.