Aiwa NSX-AJ500, NSX-AJ503 Dimmer, Setting the clock, Adjusts the brightness of the display

Dimmer

Adjusts the brightness of the display.

1Press DEMO/ECO twice when the unit is turned on, and then within 4 seconds press ENTER.

2Turn MULTI JOG to select one of the three dimmer modes or "DIM-OFF", and then press ENTER. "DIM-OFF" is the brightest and "DIMMER 3" is the dimmest.

If there is no MULTI JOG or button operation within 4 seconds, setting is canceled.

To cancel the dimmer

Repeat the above and select "DIM-OFF".

Setting the clock

1Press SHIFT+CLOCK on the remote control.

2Press for gto set the time.

Each press changes the time in 1-minute steps. Holding it down changes the time in 10-minute steps.

If for gis not pressed within 4 seconds, setting is canceled.

• MULTI JOG is also available in place of for g.

3Press ENTER or aSET.

The time display stops flashing and the clock starts from 00 seconds.

To display the time

Press SHIFT+CLOCK on the remote control.

The time will be displayed for 4 seconds, but it cannot be displayed during recording.

To switch to the 24-hour standard

Display the time and press swithin 4 seconds.

With each press, the clock alternates between the 12-hour standard and the 24-hour standard.

Tip:

In the 12-hour standard, "AM 12:00" indicates midnight and "PM 12:00" noon.

If the clock display flashes when the unit is turned off

There has been a power interruption. Re-set the clock.

En

9

01NSX-AJ500/AJ503(U)/Eng 9 12/22/00, 3:51 PM