TAPE OPERATIONS

En

Playback

Use only type I (normal) tapes.

1Press TAPE/DECK 1/2 and insert the tape in either deck.

Press zPUSH EJECT to open the cassette holder, and insert with the exposed side down and playback side facing out from the unit. Push zPUSH EJECT to close.

PUSH EJECT2Press c.

To stop playback

Press s.

To pause playback (DECK 2 only)Press a. Press again to resume.To fast forward or rewindPress for g.To select a deck (DECK 1 or DECK 2)

Press TAPE/DECK 1/2 (DECK 1/2 on the remote control) in stop mode when tapes are loaded in both decks. "T1" or "T2" lights up on the display.

To reset the tape counter

Press sin stop mode, and the tape counter on the display is reset to "0000". Opening and closing the cassette holder will also reset the tape counter.

To play continuously (DECK 1 to DECK 2)

Load tapes in both decks and start playback on DECK 1. Then, as soon as playback on DECK 1 finishes, playback on DECK 2 will start without interruption.

•The both decks play one side of the tapes.
To play back type II (High position) tapesTurn MULTI JOG until "SOFT" is displayed while playing a type II tape.Then, the unit provides the optimum playback sound for type II tapes.Notes on cassettes

•Use of 120-minute or longer tapes is not recommended since they are extremely thin and easily deformed or damaged.

•Take up any slack in the tape with a pencil or similar tool before use. Slack tape may jam in the mechanism.

•"SOFT" sound for type II tapes described above is canceled when the cassette holder is opened, the function is changed, or the unit is turned off.

Basic recording

Use only type I (normal) tapes. DECK 2 is the recording deck. Only one side of the tape can be recorded at a time.

1Insert the recording tape in DECK 2.

Press zPUSH EJECT to open the cassette holder, and insert with the exposed side down and the side to be recorded on facing out from the unit.

Wind up the tape to the desired point if needed.2Prepare the source.

To record CD(s), select the CD function and load disc(s). To record a radio broadcast, tune in to the desired station. To record a tape, insert the source tape in DECK 1 and select the TAPE function (DECK 1).

To record from connected external equipment, select the VIDEO/AUX function and prepare the equipment.

14