ECO mode

Reduces power consumption with the following operations, etc.

-The unit blacks out when the unit is turned off. Only the red indicator lights up. (Only when the clock is set.)

-If dimmer mode is set to on, the unit illumination brightens (for 10 seconds) only when you operate the unit.

1Press DEMO/ECO once when the unit is turned on, and then within 4 seconds press ENTER.

2Turn MULTI JOG to select "ECO ON" and then press ENTER.

If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled.

To cancel the ECO modeRepeat the above and select "ECO OFF".
Dimmer

Adjusts the brightness of the display.

1Press DEMO/ECO twice when the unit is turned on, and then within 4 seconds press ENTER.

2Turn MULTI JOG to select one of the three dimmer modes or "DIM-OFF", and then press ENTER. "DIM-OFF" is the brightest and "DIMMER 3" is the dimmest.

If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled.

To cancel the dimmerRepeat the above and select "DIM-OFF".
Setting the clock

1Press SHIFT+CLOCK on the remote control. When the unit is turned off, you can also press aSET.

2Press for gto set the time.

Each press changes the time in 1-minute steps. Holding it down changes the time in 10-minute steps.

If for gis not pressed within 4 seconds, the En setting is canceled.•MULTI JOG is also available in place of for g.3Press ENTER or aSET.The time display stops flashing and the clock starts from 00 seconds.To display the timePress SHIFT+CLOCK on the remote control.

The time will be displayed for 4 seconds, but it cannot be displayed during recording.

To switch to the 24-hour standardDisplay the time and press swithin 4 seconds.

With each press, the clock alternates between the 12-hour standard and the 24-hour standard.

Tip:

In the 12-hour standard, "AM 12:00" indicates midnight and "PM 12:00" noon.If the clock display flashes when the unit is turned offThere has been a power interruption. Re-set the clock.

9