1Connect the bare ends of each speaker cord to the corresponding speaker.

Be sure to use the correct cord for each speaker.

-Front speaker cords have bare leads at both ends (approx. 4 m / 13 ft.).

-Surround speaker cords are the longer cords with a plug at one end (approx. 8 m / 26 ft.).

The red plug is for the right channel and the white plug is for the left channel.

-Center speaker cord is the short cord with an orange plug at one end (approx. 3 m / 10 ft.).

The copper-colored cords go to the 0terminal of each speaker.

2Connect the cords from the front speakers to the appropriate terminals on the subwoofer.

-Right front speaker: FRONT R terminals-Left front speaker: FRONT L terminalsThe copper-colored cords go to the 0terminals.

3Connect the cords from the surround speakers to the appropriate jacks on the subwoofer.

-Right surround speaker: SURROUND R jack (red)

-Left surround speaker: SURROUND L jack (white)

4Connect the cord from the center speaker to the CENTER jack (orange) on the subwoofer.

5Connect the subwoofer to the main unit. Connect the FROM CX-LDV700U jack of the subwoofer to the TO TS-LW700U jack with the supplied connecting cord (DIN 8-pin).

•Do not connect other equipment to the TO TS-LW700U jack because this is used exclusively for the supplied subwoofer.

6Connect the supplied antennas.

Connect the FM antenna to the FM 75 Ω terminals and the AM antenna to the AM LOOP terminals.

FM antennaAM antenna7Connect the television set.If your TV set has an S-video input jack:

Connect the S-VIDEO OUT (S1) jack of this unit and the S-video input jack of your TV with an optional S-video connecting cord.

If your TV set does not have an S-video input jack: Connect the VIDEO OUT jack of this unit and the video input jack of your TV with the supplied video connecting cord (the one with plugs at both ends).

Refer also to the Operating Instructions of your TV set. The illustration shows the connection to the VIDEO OUT jack.

•If your TV set is a wide-screen set: you need to adjust the TV aspect setting later (see “TV Aspect”, page 33).

•Do not use more than one connection to connect your TV.8Connect the power supply.Plug in the AC power cords of the main unit and the subwoofer to AC outlets.

The automatic demonstration will run on the display while the power is turned off.

To deactivate the automatic demonstration, press DEMO/ ECO. The clock will flash on the display. For setting the clock, see page 13.

•Do not short-circuit the 0and 9speaker cord leads.

 

•Do not leave objects generating magnetism or objects

En

affected by magnetism near the speakers.
Remote control

While sliding the latch, pull out the battery holder from the bottom of the remote control. Place the supplied battery on the battery holder with correct polarity. Finally, insert the holder back into position.

•Replace the battery with a new one when the operational distance between the remote control and main unit becomes shorter.

•Remove the battery if the unit is not going to be used for an extended period of time.

•The remote control may not operate if it is used under intense sunlight or if its line of sight is obstructed.

Caution!

•Do not keep the battery near metallic objects such as rings, bracelets, and keys. It may cause the battery to short circuit.

•After removing the battery, be sure to keep it out of reach of children. In case it is swallowed, consult a doctor immediately.

7