Changing the display color

The display color can be selected from among the preset colors (Select color mode). 12 type of colors has already preset and 5 type of colors can be adjusted to your taste. In addition, the display color can be selected for each function. (Function color mode).

Adjust the preset colors

1Press COLOR to display "SEL-COLOR" while the power is on.

2Within 4 seconds, turn VOLUME/MULTI JOG until "COLOR M 1" to "COLOR M 5" is displayed.

3Within 4 seconds, press COLOR.

"50_50_50" is displayed and the left "50" flashes.

4Press DISPLAY repeatedly to select the color to be adjusted.-Left "50": adjust amber color.-Center "50": adjust green color.-Right "50": adjust blue color.The selected item flashes.

5Turn VOLUME/MULTI JOG to adjust the color. The level can be adjusted from "00" to "50". "50" is the brightest level.

6Repeat steps 4 and 5 to set the desired color.7Press ENTER."SET-COLOR"is displayed.

•If power is interrupted for more than approximately 12 hours, all settings stored in memory after purchase need to be reset.

•If you select "00" in each color, it displays no color on the display.•The display color may not change when you adjust only one of the colors.

Select color mode

1Press COLOR to display "SEL-COLOR" while the power is on.

2Within 4 seconds, turn VOLUME/MULTI JOG to select the color.

The selected color is automatically set after 4 seconds. It is also set when pressing ENTER within 4 seconds. In this case, "SET-COLOR"is displayed.

Function color mode

1Hold down COLOR until "-F-COLOR" is displayed.

2Within 4 seconds, turn VOLUME/MULTI JOG to select the source.

The source name and color number flashes on the display.

3Press ENTER.The source name stops flashing.4Turn VOLUME/MULTI JOG to select the color.5Press ENTER."SET-COLOR"is displayed and the color number stops flashing.6Repeat steps 2 to 5 to set the colors for other sources.

Changing the color mode

1Hold down COLOR until "ON COLOR" and "OFF COLOR" flash alternately."ON COLOR" and "OFF COLOR" flash after "-F- COLOR" is displayed.-ON COLOR: function color mode-OFF COLOR: select color mode

2Release COLOR while the desired mode flashes.

Setting the clock

1Press SHIFT+CLOCK on the remote control. When the unit is turned off, you can also press aor

ENTER.2Press for gto set the time.Each press changes the time in 1-minute steps.Holding these buttons down will vary the time in 10-minute En units.If for gis not pressed within 4 seconds, setting is canceled.

•You can also turn VOLUME/MULTI JOG to the right to advance the time and to the left to move the time back. The speed with which the time changes varies according to how fast you turn VOLUME/MULTI JOG.

3Press aor ENTER.The time display stops flashing and the clock starts from 00 seconds.To display the time while the power is onPress SHIFT+CLOCK on the remote control.The time will be displayed for 4 seconds.To switch to the 24-hour standardDisplay the time and press swithin 4 seconds.With each press, the clock alternates between 12- and 24- hour standard time.Tip:In the 12-hour standard, "AM12:00" indicates midnight and "PM12:00" noon.If the clock display flashes when the unit is turned offThere has been a power interruption. Reset the clock.

13