Aiwa Z-A60 Setting The Timer, Timer Recording, 2Press TIMER to display and “PLAY”, English, Shift

SETTING THE TIMER

ENTER

3	TIMER
	SHIFT
a

POWER 6STANDBY/ON f,g

1

2

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

1Press one of the function buttons to select a source.

2Press TIMER to display and “ PLAY”.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

3Within 6 seconds, turn MULTI JOG to designate

the timer-on time, then press ENTER or a.

Turning MULTI JOG changes both the hour and the minute.

•for gis also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

4Within 4 seconds, turn MULTI JOG to select the

duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5- minute steps.

• for gis also available instead of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or ais pressed within 4 seconds after step 4.

5Adjust the volume.

The source sound will play at the volume level set in this step when the power is turned on by the timer.

If the volume level is set to 17 or higher, however, it will automatically be set to 16 when the power is turned on.

6Prepare the source.

To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into Deck 1 or 2.

To listen to the radio, tune in to a station.

7Press POWER 6STANDBY/ON to turn off the power.

remains on the display after the power is turned off (timer standby mode), if the power-economizing mode is OFF.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

NOTE

•You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or a in step 3.

• If the power-economizing mode is ON, is not displayed in the timer standby mode.

To check the timer setting

Press TIMER.

The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 6 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily

Press TIMER repeatedly until	disappears and “ OFF” is
displayed.

To restore the timer standby mode, press TIMER once or twice to display or .

Using the unit while the timer is set

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

NOTE

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX/ PHONO (with an external timer) sources only.

Press either TUNER/BAND or VIDEO/AUX/PHONO to select a

source, then press TIMER repeatedly until appears on

the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

NOTE

•When the power-economizing mode (page 6) has been turned on, the timer recording volume level will be 0 (minimum level).

•You cannot use the timer function to record from a CD or tape.

16 ENGLISH