Alamo A60B, A72B, 00759354C manual Driveline Attachment, Slip Clutch Shield Assembly

ASSEMBLY

ASSEMBLY

Driveline Attachment

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a

shield. Entanglement in rotating shafts can kill.

.

1.Attach the slip clutch end of the driveline to the gearbox input shaft securely. (Figure Asm- 0090) Make certain that the slip clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque. Refer to Torque Chart in the Maintenance Section.

SLIP CLUTCH SHIELD ASSEMBLY

To attach the Slip Clutch Shield, follow the procedures listed below (Figure Asm-R-0091).

1.Guide shield bracket (2) through weldment shield (1) so that bracket stud screw potrudes through weldment hole and retain in place with wingnut (3).

2.Align holes of shield bracket with gearbox holes positioned around input shaft. Retain bracket to gearbox with three 3/8” x 3/4” bolts (6), 3/8” washers (4), and 3/8” lockwashers (5). Position hardware as follows: gearbox, bracket, flatwasher, lockwasher, bolt. Tighten bolts to recommended torque.

A60B/A72B 02/07 Assembly Section 3-6

©2007 Alamo Group Inc.