Alamo 00759354C, A60B, A72B manual A-Frame Assembly

ASSEMBLY

ASSEMBLY

A-Frame Assembly

To assemble the Mower’s A-Frame, follow the procedures listed below (Figure Asm-0001):

1.Place one rear brace (3) (end with smaller hole) to the inside of each lift lug located in the mid section of the mower on each side of the gear- box. Position the braces so when attached to the lugs, the braces bend towards the center of the mower. Align the holes of the lugs and braces and insert a 5/8” x 1-1/2” bolt (6) and retain with a 5/8” locknut (5). Do not completely tighten at this time.

2.One side at a time, position an A-frame leg (2) to the inside of a inner lift lug located in the front of the mower. The leg must be positioned with the smaller hole to the bottom and the bend of the leg to the center of the mower. Align the leg hole and inner lug back hole and retain together with a 5/8” x 2” bolt (7) and 5/8” flat washer (8) and locknut (5). Repeat procedure for opposite side.

3.Position bushing (13) within the toggle link (4) back set of holes (holes closest to bend). Raise rear braces (3) and position against each side of toggle link and bushing. Raise A-frame legs and position to the outside of each rear brace. Insert a 3/4” x 6” bolt (10) through A-frame legs, rear braces, toggle link, and bushing and retain with a 3/4” locknut (9).

4.Tighten all bolts and locknuts per recom- mended torque at this time.

A60B/A72B 02/07 Assembly Section 3-2

©2007 Alamo Group Inc.