Albatron Technology PX845PEV-800 Connector Configuration, Front Panel Indicator SW/LED, Function

Models: PX845PEV-800

1 49
Download 49 pages 24.97 Kb
Page 18
Image 18
Connector Configuration

Albatron Anniversary Special Edition PX845PEV-800

Connector Configuration

Front Panel Indicator: SW/LED

Phoenix PCI5

Bios

 

 

 

 

IrDA

 

 

 

+

1

2

+

FDC

 

 

 

-

3

4

-

 

 

 

-

5

6

+

 

 

 

 

+

7

8

-

 

 

 

 

 

9

10

 

USB2

 

 

 

SW/LED

 

 

 

USB3

 

CHASFAN

 

 

 

 

 

 

 

 

 

 

SW/LED

SPEAKER

CASE OPEN

JP1

LAN CHIP

 

 

 

 

 

 

 

 

PRT/COM

 

KB/MS

PCI4

PCI3

PCI2

PCI1

Winbond W83627HF

 

 

 

ATX

USB/LAN

 

 

 

 

 

AUXFAN

 

 

12V

 

 

 

 

 

 

 

AGP

Intel 82845PE

U10

 

 

Socket 478

U6

Intel 82801DB

U17

BAT1

 

DIMM1

 

 

 

 

 

 

CPUFAN

DIMM2 Front Panel Indicator: SW/LED

DIMM3 Pin Assignment

IDE2

ATX_PWR

IDE1

 

Pin Assignment

Function Function  Pin AssignmentFunction Pin Assignment
Function

1

HD LED (+)
Hard Drive

3

HD LED (-)

LED

5

Reset Control (-)

Reset

7

Reset Control(+)

Button

9

NC

NC

2

Power LED (+)

POWER

4

Power LED (-)

LED

6

Power Button(+)

Power-on

8

Power Button(-)

Button

10

NC

NC

HD LED (Hard Drive LED Connector)

This connector can be attached to an LED on the front panel of a computer case. The LED will flicker during disk activity. This disk activity only applies to those IDE drives directly attached to the system board.

RST (Reset Button)

This connector can be attached to a momentary SPST switch. This switch is normally left open. When closed it will cause the mainboard to reset and run the POST (Power On Self Test).

PWR-LED (Power LED Connector)

This connector can be attached to an LED on the front panel of a computer case. The LED will illuminate while the computer is powered on.

PWR ON (Power Button)

This connector can be attached to a front panel power switch. The switch must pull the Power Button pin to ground for at least 50 ms to signal the power supply to switch on or off (the time required is due to internal debounce circuitry on the system board). At least two seconds must pass before the power supply will recognize another on/off signal.

This mainboard complies with the ATX standard, which means the ACPI connector on this board is 2-pin. If the Power LED cable of your case uses a 3-pin adapter, you must use the 2-pin to 3-pin adapter (Please read the Appendix II).

15

Page 18
Image 18
Albatron Technology PX845PEV-800 Connector Configuration, Front Panel Indicator SW/LED, Pin Assignment, Function, Hd Led +