Alcatel Carrier Internetworking Solutions LC-2G24FP Port and Cable Specifications FE Port

Port and Cable Specifications

FE Port

The FE port provides a 10/100 Mbps Ethernet connection to a network. The RJ-45 female connector port pin-outs are shown below:

10/100 Mbps Ethernet RJ-45 Female
	Pin-Out	1	ETH Rx+	(POE negative*)
		2	ETH Rx–	(POE negative*)
		3	ETH Tx+	(POE positive*)
		4	Serial TxD**	(POE positive*)
		5	Serial TGND**	(POE positive*)
		6	ETH Tx–	(POE positive*)
		7	Serial RxD**	(POE negative*)

8	Serial RGND** (POE negative*)
Direction	*POE optional
Input
Output	**Serial optional

The port accepts a 4- or 8-conductor Category 5 UTP Ethernet cable with an RJ-45 male connector. A straight-through cable is required for connection to a network port. A crossover cable is required for connection to a management workstation.

For cables that run through plenums or air-handling spaces as described in NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article

800.50and marked accordingly for use in plenums and air-handling spaces with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be sure to install cables in accordance with all applicable local regulations and practices.

Alcatel OmniAccess 6000 LC-2G24FP Installation Instructions 7