Alcatel Carrier Internetworking Solutions LC-2G24FP Fe Lnk/Act Led, Status, Description

OmniAccess 6000 LC-2G24FP Installation Notes: Installation Guide

2Module Handle

This handle is used for removing or inserting the module into the switch chassis.

CAUTION—Do not use the line card handle to lift or move the Alcatel Wireless LAN Switch. Serious damage could result.

324 FE Ports

These ports are used to connect APs and wired LAN segments to the Alcatel Wireless LAN Switch. These ports provide 10/100 Mbps Ethernet connectivity, as well as power and serial connectivity. See “Port and Cable Specifications” for more information.

ALNK/ACT LED

Each FE port has its own LNK/ACT LED, located at the left side of the port. During operation, these LEDs provide the following status information:

TABLE 1 FE LNK/ACT LED

Status	Description
Off	No Ethernet link on the port.
Green	An Ethernet link has been established on the port, but no
	data is currently being transmitted or received.
Flashing	The port is transmitting or receiving data. The flashing
Green	rate is proportional to your network activity.
Amber	The Ethernet link on the port is encountering errors.

BPOE LED

This LED is supported only on line cards that support POE (such as LC-24FE-2GE-SPOE) and provides the following POE status information:

TABLE 2 FE POE LED

Status	Description
Off	The port is disabled or the attached device has not
	requested power. POE is not being provided by the port.
Green	POE is being provided to the attached device.
Amber	The attached device has requested power, but POE is not
	being provided by the port.

2

Part 031659-00 May 2005