Using the 1:5 HDD Copy Cruiser IDE/SATA

Main Menu

Async Copy

The function “Async Copy” allows you to insert target drives during the copying operation. During the process, you can insert another drive as a target of the Async Copy operation and the unit will automatically copy to this new drive as well.

1.Load the source HDD and the target HDDs into the 1:5 HDD Cruiser. The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one below will be displayed.

2. Async Copy

ENT ESC

Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.

2.Press ENT to start copying. The system will auto-detect the hard drives. The following information will be displayed.

Detect Drives

Please wait...

ENT ESC

3.During the copy process the 1:5 HDD Cruiser will display progress information.

Copy- 36MB/s 235.7GB

0%

1:48

ENT ESC

The amount of data remaining to be transferred (shown in gigabytes), and time will be displayed as the percentage of completion increases.

Note: The copying speed, capacity and duration may vary from one source hard drive to another.

www.aleratec.com15