Using the 1:11 HDD Copy Cruiser IDE/SATA
Main Menu
Adv Setup
Adv Setup: Update Firmware
This function is used to update the 1:5 HDD Cruiser firmware to a later version.
Note: Firmware updates are available from Aleratec technical support.
1.a CD method
Open the case of the 1:5 HDD Cruiser . Disconnect the SATA cable from the blue connector on the controller board. Connect a SATA DVD/CD drive (not included) to the blue connector. Place the firmware CD in the DVD/CD drive.
1.b Hard Drive method
Format a hard drive and create a single partition to the smallest capacity allowable. Copy the firmware file into the root directory of this partition.
2.Power on the 1:5 HDD Cruiser. Once the system has completed its startup process, press and hold the ESC button for about 3 seconds to access “Adv Setup”. The following screen will be displayed.
11. Adv Setup
ENT ESC
3.Use the arrow buttons () to select “Update Firmware”, and then press ENT. The system will begin scanning for a new firmware version. If found, screens similar to the following will be displayed.
Searching F/W... | | Update F/W | 1.04N |
Please Wait... | To *.** Yes |
| |
|
|
|
|
4.Press ENT to begin the firmware update. If the upgrade is successful, the system will restart automatically.
www.aleratec.com39