Place a level on the cabinet top and check if the unit is level from side to side and front to back.

NOTE: Level must rest on raised portion of top panel. Refer to Figure 20.

1

5

4

3

2

SWD833N

1Level

2Rubber Foot

3Leveling Leg

4Locknut

5Unit Base

Figure 20

If unit is not level, tilt unit to access the front and rear leveling legs. For easier access to leveling legs, prop up unit with a wooden block. Refer to Figure 21. Loosen the locknuts and adjust legs by screwing into or out of unit base.

1

SWD832N

1Wood Block

Figure 21

Make sure that the unit does not rock. When unit is level and does not rock, tighten locknuts securely against bottom of unit base. If these locknuts are not tight, unit will move out of position during operation.

Leveling legs can be adjusted from inside the unit with a 7/8 inch deep well socket. All four legs must rest firmly on the floor so the weight of the unit is evenly distributed. The unit must not rock and must be level from side-to-side and front-to-back.

NOTE: Do not slide unit across floor once the leveling legs have been extended. Legs and base could become damaged.

Place rubber feet (supplied in accessories bag) on all four leveling legs. Refer to Figure 20.

Verify that unit does not rock.

802715

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

17