Alliance Laundry Systems CFD14C, CFD16C Water Connection

Water Connection

WARNING

To avoid personal injury, recommended inlet water temperature should be no higher than 125° Fahrenheit (51° Celsius).

W709

The models are delivered with three hoses with 3/4 inch hose connectors. These hoses fit the water inlet valves of the machine and the main water inlet taps. To ensure the optimal functioning of the water inlet valves, the water pressure on the inlet should be between 30-85 psi (2-5.86 bar). If the pressure is too low, the cycle time will increase considerably.

Connections should be supplied by a hot and a cold water line per national and local codes.

To connect water service to machine with rubber hoses, use the following procedure:

1.Before installing hoses, flush the water system for at least two minutes.

2.Check filters in the washer-extractor’s inlet for proper fit and cleanliness before connecting.

3.Hang the hoses in a large loop, do not allow them to kink.

If additional hose length is needed use flexible hoses.

Installation

Pressure of 30-85 psi (2-5.86 bar) provides best performance. Although the washer-extractor will function at lower pressures, increased fill times will occur with some loss of supply flushing.

Suitable air cushions should be installed in supply lines to prevent “hammering.”

Water Supply Information

Model	18	30	33	40

Water inlet	0.75 in.	0.75 in.	0.75 in.	0.75 in.
connection size	(19 mm)	(19 mm)	(19 mm)	(19 mm)

Number of	3	3	3	3
water inlets
(standard)

Recommended	30-85 psi	30-85 psi	30-85 psi	30-85 psi
pressure	(2-5.86	(2-5.86	(2-5.7	(2-5.7
	bar)	bar)	bar)	bar)

Inlet flow	5.3 gal/	5.3 gal/	5.3 gal/	5.3 gal/
capacity	min	min	min	min
	(20 l/min)	(20 l/min)	(20 l/min)	(20 l/min)

	Table 5

9001909