Programming
NOTE: If machine is equipped with a card reader, or interfaces with a control/remote pay system, setting “con1”/ “dEno” and “con2”/ “dEno” equal to the vend start amount (“Strt”/ “Ant”) will allow starting with one pulse and is recommended. The card or central remote pay vend amount should match the “Strt”/ “Ant” setting.
15.Display shows “con1”, “dEno” next, then a number such as 25. This means that the coin 1 denomination is 25 cents for single coin meters. For example, a U.S. quarter coin meter would be set for 25 cents or this would be the amount for one of the two denominations for a dual coin meter, such as a U.S. quarter for a dollar/quarter dual coin meter. The vend price programmed above will count down by this amount each time a coin is added.
16.Press the (∧) or (∨) keypad to decrease or increase this amount.
17.When correct, press START (Enter) keypad.
18.Display shows “con2”, “dEno” next, then a number such as 100. This means that the coin 2 denomination is 100 cents. This is the coin denomination for coin meters that can process two types of coins – such as a U.S. quarter/dollar coin meter. The second coin input would be one dollar. For single coin meters, press START (Enter) keypad to continue. The vend price programmed above will count down by this amount each time this second coin type is added.
19.Press the (∧) or (∨) keypad to decrease or increase this amount.
20.When correct, press START (Enter) keypad.
21.Display shows “Strt”, “Ant” next, then a number such as 150. This means that the start amount is 150 cents. This is the vend price required to operate a wash cycle.
22.Press the (∨) or (∧) keypad to decrease or increase this amount.
23.When correct, press START (Enter) keypad.
24.Display shows “0000” when complete. Return the Program/Run switch to the right and close the lid. The display will show new vend price.
Cycle and Error Count
The control logs cycle count (total of all cycles completed).
1.To read, enter PROGRAM Mode. Refer to Entering Program Mode.
2.Press START (Enter) keypad. Display will show the cycle count.
3.Press START (Enter) keypad. Display will show certain error conditions that may have been recorded by the control.
4.Read the information when consulting technical assistance as needed.
5.Step through the error log by pressing START
(Enter) keypad repeatedly until display reverts to normal PROGRAM Mode (“0000” or temperature).
Programming Cycle Segments
The machine is preprogrammed with eight wash cycle formulas that can be edited.
To edit any of these cycles, enter PROGRAM Mode. Refer to Entering Program Mode. In PROGRAM Mode, cycles are selected by number (1 through 8) as opposed to the RUN Mode, where cycles are selected by pressing one of the eight corresponding keypads. The keypads must serve different functions in each mode because there are more functions than keypads in PROGRAM Mode.
In RUN Mode the top left keypad selects Cycle 1, the (∧) keypad directly below it selects Cycle 2, etc. Figure 3 shows which keypad selects each cycle in RUN Mode.
1.After entering PROGRAM Mode, display will show “0000” or temperature (if machine is configured for heat).
2.Press the (∧) keypad to enter Cycle Programming Mode. The display will reference cycles by number. Cycle 1 will show first.
3.Use the (∧) or (∨) keypad to select cycle to be edited.
4.Press START (Enter) keypad to move into the menu of options.
16 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232157 |