Programming

NOTE: The machines are factory programmed with basic cycles to make the units operational without programming at installation.

Entering Program Mode

1.Open machine lid.

2.Locate Program/Run switch on the computer board. This is accessed through a cutout in the metal control unit cover. This switch protrudes from the rear of the electronic control unit cover.

3.Flip switch to the left (as seen from front of machine) to enter PROGRAM Mode.

4.Display will show “0000” or temperature or “tSFL” (depending on version of the control).

Determining Firmware ID Code

1.Turn on the main power source (circuit breaker or cut-off switch on wall).

2.Display will show Firmware ID code (i.e., “C2dS” and “CvdS” etc…).

3.Record Firmware ID Code for future reference.

12

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232157