Alliance Laundry Systems F232157R7 manual 20

Programming

Options for Each Segment

Cycle Steps Available
(NOTE: WASH, ADD BLEACH, RINSE	Display	Setting Options for Cycle Steps
and SPIN LEDs light ONLY when a
cycle formula is in operation.)
Wash 1 (displayed as “USH1”)
Time for Agitation (excludes fill, drain,	GEnt	0 or 2-30 minutes in agitation step (increases/decreases in
spin and heat)		one-minute increments). Refer to Table 3 for operation of
	norn
		each agitation segment
Fill valves (temperature)	CFIL	Cold, Hot or Both (warm) water fills or Extra fill (must be
		configured for “EFIL” in SETUP Mode)
	HFIL
	bFIL
	EFIL
Fill water level control	LO	Low, Medium or High water level
	nEd
	HI
Supply	SUP0	SUP0 for No Supply or Supply 1-3,6 (Refer to Table 2 for
		operation of each supply selection)
	SUP1
	SUP2
	SUP3
	SUP6
Heat (Models with heat or heat capability)	HEAt	00F (no heat for segment) or 80°F to 205°F
		00C (no heat for segment) or 27°C to 95°C
	noHt
Drain (Final segment drains in stop	drAI	Drain or No Drain (if No Drain programmed, will skip spin
routine if No Drain is programmed)		segment associated with Drain segment)
	nodr
Spin time	SPIn	00 for No Spin or 30-240 seconds (increases/decreases in
		one-second increments)
	tInE
Wash 2 (displayed as “USH2”)
Time for Agitation (excludes fill, drain,	GEnt	0 or 2-20 minutes in agitation step (increases/decreases in
spin and heat)		one-minute increments). Refer to Table 3 for operation of
	norn
		each agitation segment
Fill valves (temperature)	CFIL	Cold, Hot or Both (warm) water fills or Extra fill (must be
		configured for “EFIL” in SETUP Mode)
	HFIL
	bFIL
	EFIL
Fill water level control	LO	Low, Medium or High water level
	nEd
	HI
Supply	SUP0	SUP0 for No Supply or Supply 1-3,6 (Refer to Table 2 for
		operation of each supply selection)
	SUP1
	SUP2
	SUP3
	SUP6
	Table 1 (continued)

18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232157