Step 6: Remove the Shock Sleeves and Shipping Brace
Remove front access panel by removing the two screws at the bottom of the panel.
Remove the five bolts and lockwashers from shipping brace with 9/16 in. wrench and remove brace. Refer to Figure 10. One is holding the brace to the weight.
Remove this bolt first. Four bolts are located on the washer base. Remove the two front bolts next and then the two rear bolts. Remove all four shock sleeves by pulling on the yellow rope. Remove label from front side of front access panel or shipping brace and place on backside of front access panel for future reference.
NOTE: The shipping brace, bolts, washers and shock sleeves should be saved and MUST be reinstalled whenever the washer is moved more than 4 feet (1.22 m). Refer to
Store the shipping materials in the accessories bag. Save materials for use whenever the washer is moved.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
6 inches (152.4 mm) in any direction after shipping brace has been removed. Shock absorbers may separate and damage to washer may result. For leveling purposes, the washer may be tilted a maximum of 6 inches (152.4 mm) in any direction.
|
| Installation |
1 |
|
|
|
| 2 |
|
| 3 |
| 4 | FLW2124N |
|
| |
|
| FLW2124N |
1 | Shock Sleeves |
|
2 | Motor Mount |
|
3 | Hooked End of Shipping Brace | |
4 | Bolts and Lockwashers |
|
Figure 10
Step 7: Wipe Out Inside of Wash Drum
Before using washer for the first time, use an
FLW2126N
Figure 11
802734 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 13 |
