Step 5: Remove the Shock Sleeves and Shipping Brace

Remove front access panel by removing the two screws.

Remove 9/16" bolts and washers from shipping brace with wrench and remove brace. Remove shock sleeves by pulling on the yellow rope.

Remove label from front side of front access panel and place on back side of front access panel.

NOTE: The shipping brace, bolts, washers, and shock sleeves should be saved and MUST be reinstalled whenever the washer is moved more than 4 feet. Do not lift or transport washer from front or without shipping materials installed. Refer to Moving Washer to a New Location section for instructions.

Store the shipping materials in the bag provided in the accessories bag. Save materials for use whenever the washer is moved.

Reinstall front access panel.

1

2

4

3

H336I

1Shock Sleeves

2Motor Mount

3Bolts and Washers

4Hooked End of Shipping Brace

Installing the Washer

Step 6: Wipe Out Inside of Wash Drum

Before using washer for the first time, use an all- purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside washer drum.

H337I

H337I

Step 7: Plug In the Washer

Refer to section on Electrical Requirements and plug the washer in.

D254I

H008I

Step 8: Check Installation

Refer to Installer Check on the back cover of this manual and make sure that washer is installed correctly.

685980

11