Installing the Washer

Step 1: Position Washer Near Installation Area

IMPORTANT: Install dryer before washer. This allows room for attaching exhaust duct.

Move washer as close to the desired area of installation as possible.

D772I

D772I

Step 2: Connect Water Inlet Hoses

NOTE: Refer to section on Water Supply Requirements before connecting water inlet hoses.

Remove the four plain rubber washers from accessories bag, and install them according to the illustration.

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

IMPORTANT: Thread hose couplings onto valve connections finger-tight, then approximately 1/4 turn with pliers. DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

1

2

3

4

W528I

1Rubber Washer (Plain)

2Install This End of Hose to Water Supply Faucet

3Install This End of Hose to Valve Connections at Rear of Washer

4Inlet Hose

1

2

3

 

Water

 

Mixing

4

Valve

 

H328I

H328I

1Water Supply Faucets

2Cold Water Connection

3Hot Water Connection

4Water Inlet Hoses

685980

7