Cycle Selection

Note: Press keys at their centers just hard enough to activate them.

As coins are inserted in the coin meter slot, the display shows the remaining amount to start. It will continue to count down until the start price is satisfied.

Once the amount to start is satisfied, the display will read “CYxx” where “xx” represents a cycle number. Press the Up or Down key until the desired cycle number is displayed. Press the Start key to start the cycle. For a more detailed description of the preprogrammed cycles, see the cycle charts at the end of the Programming section.

Note: If the coin meter is equipped with a coin blocking coil, the machine must be loaded and the door closed before coins can be added. The meter will not accept coins until these two conditions are met.

If the computer detects that the door is not properly closed when the Start key is pressed, the display will alternately read “SHUT” and “door.” Verify that the door is properly closed, and press Start again to begin the desired cycle.

Cycle Execution

To display the temperature of the water while a cycle is running, press the Up key. To display the number of the cycle in progress, press the Start key.

Operation

Note: The computer does not count down the remaining cycle time during fills and drains or prior to first achieving the programmed heat temperature when heating. The computer resumes counting down cycle time once the programmed fill level is reached, when the machine has drained, and after a programmed heat temperature is reached.

Each of the 16 cycles consists of eight segments: Prewash, Wash, and Fills 1–6. A description of the various steps in a cycle segment follows:

Fill

After the Start key is pressed, the door locks, the drain closes, and the machine begins filling to the programmed level. Each programmed segment begins with a fill. The display counts down the remaining cycle time in minutes and seconds while the cycle is running, except as noted above.

If a supply is programmed in a step, the supply dispenser will flush during the fill of that segment. If the programmed supply is supply 2 (“sup 2”), the display will flash “bLCH” alternately with the cycle time while supply 2 is on. This signals the user to manually add liquid bleach in the middle supply dispenser compartment.

Note: If the computer does not detect the programmed water level after attempting to fill to that level for 30 minutes, the display will flash “FILL”/“STOP” while sounding the buzzer briefly. The computer will then abort the cycle. This indicates a serious problem. Contact a qualified service technician.

17

F232061