Didn’t drain within time
Enter to retry
Clear to stop
Done Cycle CC
Please open door
Didn’t drain within time
During step N
(CC = cycle number;
N = step number in which the alarm occurred).
Operation
Fill Alarm (Continued)
Possible Faults:
●Wiring is not connected properly to the inlet valves.
●The inlet valve is broken.
●There is a problem with the water supply.
●The inlet valves are blocked by dirt.
●The water pressure hose is broken or not connected properly.
Drain Alarm
If drain step is NOT followed by a spin and if machine does not empty within the time programmed for drain step, a drain alarm occurs. Display will read “Didn’t drain within time.”
During drain alarm, beeper sounds on and off, and machine continues attempting to drain. If machine does not empty, condition continues. If Enter key is pressed, drain alarm ends, and drain step starts over at beginning. If machine has not emptied when drain step time expires, alarm occurs again. If Clear (STOP) key is pressed while drain alarm is in effect, display shows water level (inches or centimeters), but otherwise takes no new action since machine has not emptied.
When cycle ends, display repeats following messages briefly until door is opened (to indicate that an alarm condition occurred in the cycle):
If machine drains during a spin step prior to accelerating into high speed and if machine has not emptied within approximately 2 minutes of starting drain procedure, a drain alarm occurs. There is no rotation during this alarm; messages displayed are identical to drain alarm during a drain step not followed by a spin. Pressing Enter (START) during drain alarm in a spin step ends alarm and begins spin step again at start, with machine rotating at wash speed forward, then to distribution speed. After drain begins (i.e., drain open, pumping begins), if 2 additional minutes elapse, alarm occurs again.
9001001 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 17 |