Installation/Operation Supplement

Mounting Bolt Installation (If Required)

1

2

3

After the concrete has cured and the anchors are installed, proceed as follows:

1.

Place the washer-extractor adjacent to the

 

foundation. Do not attempt to move it by pushing

 

on the sides. Always insert a pry bar or other

 

device under the bottom of the frame of the

 

washer-extractor to move it.

2.

Place the washer-extractor carefully over the

 

anchors.

3.

Put bolts through the machine in the anchors and

 

fasten them. The diameter of the bolt must be

 

minimum 1/2-13 or 12 mm.To level machine, fill

 

the spaces between the machine base and floor

 

with machinery grout. Grout completely under

6in.

(152 mm)

4

CFS485N

 

all frame members. Remove front and rear panels

 

to gain access to all frame members. Force grout

 

under the machine base until all voids are filled.

4.

Remove the spacers carefully, allowing the

 

machine to settle into the wet grout.

5.

Position washers and locknuts on machinery

 

anchor bolts and fingertighten to machine base.

CFS485N

1Base Frame

2Bolt

3Washer

4Anchor Bolt/Plug

Figure 3

6. After the grout is completely dry, tighten the

locknuts by even increments – one after the

other – until all are tightened evenly and the

machine is fastened securely to the floor.

10

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9002062 (EN)