Installation
Control Function Test
The machine should be cleaned after the installation is complete. A function test should then be executed on the unloaded machine:
1.Check the power supply for correct voltage, phase, and cycles to be sure they are correct for the machine.
2.Open manual
3.Turn on electric power.
4.Check the lid interlock before starting operation:
a.Turn extract timer dial counterclockwise to the two minute mark, remain for three seconds, and return dial to “off” position.
NOTE: Step 4a must be performed every time power is disconnected from machine to reset rotation detector.
b.Press the lid release button and open the lid to the
c.Attempt to start the machine with the lid open. The machine should not start with the lid open.
d.Close the lid without locking it and attempt to start the machine. The machine should not start with the lid unlocked.
e.Close and lock the lid and start a cycle. Attempt to open the lid while the cycle is in progress. The lid should not open.
If the lid lock and interlock are not functioning properly, call a service technician.
5.Run a complete cycle, checking operation of water inlet valves, drain, and extract functions.
6.Check that cylinder rotation is clockwise in the extract step. If rotation is not clockwise in the extract step, disconnect power and have a qualified electrician reverse lines L1 and L2 at power input block.
16 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232212 |