Drain
If the cycle program segment calls for a drain, the drain valves will open after the programmed segment time has elapsed. If a spin step follows a drain step, the cylinder will turn clockwise (forward) at wash speed for several seconds at the beginning of the drain step. This clockwise direction mirrors the spin rotation and is, therefore, also considered forward.
The cylinder then accelerates to distribution speed to help ensure that the load is evenly distributed. The drains open several seconds later.
NOTE: The machine should drain in 30 seconds. If the machine fails to drain, contact a qualified service technician.
If the cycle program segment does not call for a drain, the computer moves to the next segment of the cycle program. If the segment is at the end of a cycle program, the computer goes into the stop routine.
If the cycle program segment does not call for a spin, the cylinder will continue to turn at wash speed throughout the drain step. When the drain has completed, the computer moves to the next segment of the cycle program. If the segment is at the end of a cycle program, the computer goes into the stop routine.
NOTE: The drain step in the final segment (Fill 9) cannot be skipped.
Spin
After the drain sequence ends, the speed of the cylinder increases to the extract speed if the programmed spin time is not zero. The displayed time resumes counting down at
After the programmed spin time has elapsed, the computer moves on to the fill step in the next segment of the cycle. If the spin is at the end of the cycle, the computer begins the stop routine.
Operation
Stop Routine
When the computer concludes the wash cycle or when the Stop key is pressed while a cycle is in progress, the computer goes into the stop routine.
The stop routine sequence:
●All inputs are turned off
●A brief pause, allowing the cylinder to coast down if in extract
●Brief rotation counterclockwise at wash speed
●A brief pause
●Brief rotation clockwise at wash speed
●A brief pause
●The display shows “donE”
●The door interlock is energized, allowing the door to be opened
If the stop routine seems excessively long, check for “FULL” or “rotA” messages. If this occurs, contact a qualified service technician.
WARNING
NEVER insert hands or objects into basket until it has completely stopped. Doing so could result in serious injury.
SW012
Once “donE” is displayed, open the door by pressing and holding the
The machine is now ready to begin another wash cycle.
NOTE: A test cycle is provided as a means of verifying proper machine operation. Refer to the Programming section for instructions on running the test cycle.
F232123 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 17 |