Alliance Laundry Systems UW100VV, UW125VV Start-Up, Opening Door, Loading, Cycle Selection, NOTE: Press keys at their centers just hard enough to activate them

Start-Up

Turn on the main power source (circuit breaker or cutoff switch on the wall).

An identification code will appear for approximately five seconds. Then the display will flash “Hold” briefly.

The display will then read “CY” followed by a two- digit cycle number (01 – 30) to indicate that a cycle can be selected. This display will be shown at all times when power is on between cycles, indicating that the door-unlock solenoid will function if the door-unlock button is pressed. The machine is then ready for loading and unloading.

Opening Door

Press and hold the door-unlock button next to the door handle and turn door handle upward.

Loading

CAUTION

Be careful around the open door, particularly when loading from a level below the door. Impact with door edges can cause personal injury.

SW025

Load the machine to full capacity whenever possible, but do not exceed the rated dry-weight capacity of the machine if the fabric to be washed is quite dense, closely woven, and heavily soiled. Overloading can result in an inferior wash. The operator may need to experiment to determine load size based on fabric content, soil content, and level of cleanliness required.

NOTE: Washing small loads can cause out-of- balance conditions which shorten life of bearing, seals, basket/shaft assembly, etc.

WARNING

Never operate the machine with a bypassed or disconnected balance system. Operating the machine with severe out-of-balance loads could result in personal injury and serious equipment damage.

SW039

Operation

When loading is complete, ensure that all fabric is inside the basket. Then close and lock the door by rotating the door handle clockwise until the door handle is horizontal. The machine should not start or run unless the door is both closed and locked.

CAUTION

Check the door safety interlock daily before the machine is placed in operation.

SW024

NOTE: When washing items which may disintegrate, such as mop heads or sponges, use laundry net bags to prevent drain blockage.

Cycle Selection

NOTE: Press keys at their centers just hard enough to activate them.

Press the Up or Down key until the desired cycle number is displayed. The computer will skip blank (unprogrammed) cycles automatically. Press the Start key to start the cycle. For a more detailed description of the preprogrammed cycles, refer to the cycle charts at the end of the Programming section.

If the computer detects that the door is not properly closed when the Start key is pressed, the display will read “door” until the door is closed and locked. Press Start again to begin the desired cycle.

F232123