Alliance Laundry Systems UW100VV, UW125VV 28

Programming

p. The motor rotates clockwise (forward) at normal wash speed for 60 seconds. The display alternately flashes “norn” and “For”.

q.The display begins alternately flashing “drAI” and “For” (drain step, cylinder rotating at wash speed). The motor continues to rotate clockwise (forward) at normal wash speed for seven seconds.

r.The motor accelerates to distribution speed. The display alternately flashes “drAI” and “dISt” (drain step, cylinder rotating at distribution speed).

s. The drain opens between 15 to 27 seconds into the drain step. The water level indicator lights on the display will begin to go out, one by one, as the machine drains past each water level.

t. The computer begins monitoring the balance signal from the AC inverter drive several seconds after the water level switch indicates that water level has dropped below low level.

u. If the balance signal indicates that the wash load is unbalanced, the cylinder will slow down to wash speed for seven seconds in an attempt to redistribute the load. The computer will make as many as seven attempts, as needed, in this cycle.

NOTE: If the machine utilizes the overtravel limit switch balance detection system, the computer will proceed through the drain step and will time steps t and u. The computer will then proceed to step v.

v.The cylinder accelerates to low spin speed. The display shows “SPn1” (cylinder rotating at low spin speed). The basket rotates at low spin speed for 60 seconds.

w.The cylinder accelerates to medium spin speed. The display shows “SPn2” (cylinder rotating at medium spin speed). The basket rotates at medium spin speed for 60 seconds.

x.The cylinder accelerates to high spin speed. The display shows “SPn3” (cylinder rotating at high spin speed). The basket rotates at high spin speed for 60 seconds.

y.All outputs are turned off for roughly

20 seconds. The display shows “SdLY” (spin coast delay).

z.The computer performs the normal stop routine.

The door interlock is energized (allowing the door to be opened), provided that the water level switch indicates that water has fallen below low level and that the AC drive indicates that the motor has stopped.

F232123