Alliance Laundry Systems Washer/Dryer Before you start, Electrical requirements, Panel a

Before you start...

Check locatlon where washer/dryer will be installed. Proper installation is your responsibility. The washer/dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Make sure you have everything necessary for correct installation.

Location should be large enough to fully open dryer door 90”. (See Panel E for ‘Recessed and closet installation instructions” and “Product dimensions,“)

Check	utllltles: Proper				electrical	supply
must be		available.				I-
Dryer may be			exhausted			f
from rear or left or right side.
Exhausting		through the			side
requires	Side		Exhaust	Kit
LCK4600.		See	“Exhaust
requirements,			ti Panel	B.

10.2cm (4 In) metal exhaust duct Is required.

Standplpe	draln	system	\
needs a 5 cm (2 in)
diameter	standpipe
with a minimum carry-
away capaclry		or_	n

65.6litres (14.2 Imperiafi) gallons) per minute.

Top of standpipe

beatleast71.1 cm (28 in) high and no higher than 121.9 cm (48 in) from floor.

Important : Observe all governing codes and ordinances.

Check code requirements. Some codes limit or do not permit the installation of clothes dryers in garages, closets, mobile homes and sleeping quarters. Contact your local building inspector.

Grounded electrlcal outlet is required. See

“Electrical requirements,” Panel A.

I

I Electric Shock Hazard

It Is the customer’s responslblllty:

l To contact a quallfled electrlcal Installer.

. To assure that the electrlcal InstallatlOn Is adequate and In conformance wlth the Canadlan Electrlcal Codes, and all local codes and ordinances.

Failure to do so could result In flre, electrlcal shock or other personal InJury.

Hot and cold water faucets must be within

1.2meters (4 feet) of the back of the washer/dryer and provide water pressure of 34 to 690 kPa (5-100 psi).

Water heater: Set to deliver 60°C (140°F) water to the washer.

Laundry tub drain sysiem needs a 75.5 litres (16.6 Imperial gallons) laundry tub. Top of tub must be at least 71 .l cm (28 in) high

no higher than 121.9 cm (48 in) from

If a longer drain hose is needed, Drain Hose Part No. 388423, and Hose Connection Kit Part No. 285442, are available from your authorized parts distributor.

Floor drain system

requires a siphon break, Part No. 285320, available from your authorized parts distributor.

I \-

Personal Injury Hazard

More than one person Is required to Ilft. tilt, or move thls washer/dryer because of Its weight and size.

Failure to follow these lnstructlons may result In personal InJury.

Fire Hazard

lDo Not use or store gasoline, palnt, thlnners and other flammable materials near washer/dryer. Fumes from such materials could result In flre or explosion.

l Never Install washer/dryer up agalnst draperies or curtains or on carpet. To do so may result In a fire.

l Keep any and all Items from klllng or collecting behlnd the washer/dryer. Failure to do so may result In a fire.

l Replace all access panels before operatlng washer/dryer.

Failure to follow these lnstructlons may result In a fire, exploslon or electrlcal shock.

.- -..pport washer/dryer weight wifi water and clothes of 170 kg (375 lb).

Tools and materials needed for installation:

0.64 cm (l/4 in)

socket wrench or nut driver

Product Damage

Do Not store or operate washer/dryer below 0°C (32°F) (some water may remaln In washer). Proper operatlon of dryer cycles requires temperatures above 7.2% (45°F). See Use & Care Guide for “Wlnterlzlng” InformatIon.

Failure to do so may result In damage from freezlng.

Electrical requirements

OBSERVE ALL GOVERNING CODES AND ORDINANCE

Electrlcal Shock Hazard

. Electrlcal ground Is required on thls product.

l Improper connectlon of the equlpment- groundlng conductor can result In a rlsk of electrlcal shock.

l Check wlth a quallfled electrlclan If you are In doubt as to whether the appliance Is properly grounded. Do Not modify the power supply cord plug. If It will not flt the outlet, have a proper outlet Installed by a quallfled electrlclan.

l Do Not use an extension cord wlth thls appliance. Such use may result In a fire, electrlcal shock or other personal InJury.

lDo Not have a fuse In the neutral or grounding clrcult. Thls could result In a rlsk of electrlcal shock.

Failure to follow these lnstructlons could result In serlous InJury or death.

1.A four-wire, single-phase, 120/240- volt, 60- Hz, AC only electrical supply is required on a separate 3(lampere circuit, fused on both sides of the line. (Time-delay fuse or circuit breaker is recommended.)

2.This washer/dryer is equipped with a four- wire, 30-amp rated flexible-type power supply cord. It must be plugged into a mating 30-amp receptacle (NEMA-type 14-30R). See Figure 1.

Use 30-amp receptacle where local codes permit flexible-type supply cord (pigtall).

14-30RI-wire

receptacle

Figure 1

Panel A