Allied Telesis 54266-02 manual AR441S ADSL Router Hardware Platform, Enhancements, Level

8 AR441S ADSL Router Hardware Platform Patch Release Note

Level 4

PCR: 40441 Module: IPG, VRRP Level: 4

If VRRP was enabled and a reset ip command was issued followed by a disable vrrp command, then the device would still reply to pings, even though the device was no longer the VRRP master. Duplicate echo replies were seen on the device sending the pings. This issue has been resolved.

Enhancements

PCR: 40521 Module: TACACS+

The new command show tacplus has been added. This command shows the module status, number of servers, and number of logged in users.

PCR: 40677 Module: ADSL

The new ADSL Annex B firmware has been incorporated to allow compliance with UR-2 specifications.

AR441S ADSL Router Hardware Platform

Patch 54266-01 includes support for the AR441S ADSL (Annex B) router.

Each AR441S router consists of a base CPU card, enclosure, and power supply.

The base CPU card supports:

■One Asymmetric Digital Subscriber Line (ADSL) Annex B port.

■Five 10/100 LAN switch ports.

■One asynchronous RS-232 (ASYN0) port.

The PIC bay can accommodate any of the following PICs:

•AT-AR020 PRI E1/T1 PIC, one Primary Rate E1/T1 port.

•AT-AR021(S) BRI-S/T PIC, one Basic Rate ISDN S/T port.

•AT-AR021(U) BRI-U PIC, one Basic Rate ISDN U port.

•AT-AR022 ETH PIC, one Ethernet LAN AUI/10BASE-T port.

•AT-AR023 SYN PIC, one Synchronous port with universal 50-way AMPLIMITE connector.

•AT-AR024 ASYN4 PIC, four Asynchronous ports with RJ-45 connectors.

•AT-AR026 4ETH PIC, four 10BASE-T/100 BASE-TX auto-negotiating ports with RJ-45 connectors.

•AT-AR027 VoIP-FXS PIC, two Foreign Exchange Subscriber (FXS) ports with RJ-11 connectors.

Patch 54266-02 C613-10417-00 Rev B