Allied Telesis 86222-25 PCR Module Ospf Level, PCR Module TTY Level, PCR 03346 Module Snmp Level

4 Patch Release Note

PCR: 03240 Module: OSPF Level: 2

A fatal error occurred when OSPF was under high load. This issue has been resolved.

PCR: 03253 Module: FIREWALL Level: 2

Inbound TCP sessions through the firewall (e.g. Telnet and FTP) failed when the PORT parameter was set to ALL in the SET FIREWALL POLICY RULE command. This issue has been resolved.

PCR: 03255 Module: FIREWALL Level: 3

The firewall doubled the IPSPOOF event timeout from 2 minutes to 4 minutes. This issue has been resolved.

PCR: 03302	Module: SWI	Level: 3
Following a period of high traffic load, the CPU utilisation would
occasionally fail to drop below 40%. This issue has been resolved.
PCR: 03314	Module: SWI	Level: 2

Layer 3 filters that matched TCP or UDP port numbers were being applied to the second and subsequent fragments of large fragmented packets. This issue has been resolved.

PCR: 03332 Module: TTY Level: 2

A log message is now created when a user is forced to logout from an asynchronous port when another user (i.e. someone connected via Telnet) resets the asynchronous connection with the RESET ASYN command.

PCR: 03346 Module: SNMP Level: 4

Sometimes the Agent Address field in SNMP traps was not the same as the IP source address. This meant that sometimes the NMS did not send an alarm to the network manager when traps were received from switches. This issue has been resolved.

PCR: 03368 Module: SWI Level: 2

Layer 2 packets transmitted out of the mirror port were being tagged erroneously. This issue has been resolved.

PCR: 03378 Module: DHCP Level: 2

DHCP sometimes suffered a fatal error when a range of IP addresses was destroyed. This issue has been resolved.

PCR: 03385 Module: FILE, INSTALL, SCR Level:

Critical files (prefer.ins, config.ins and enabled.sec) are now copied from NVS to FLASH at boot time if they do not exist in FLASH, or if the NVS version of the file is different from the FLASH version.

PCR: 03386 Module: SWI Level: 2

If the SET SWITCH L3FILTER MATCH command had nothing specified for the IMPORT and EMPORT parameters, and there was an existing match entry in the filter table, the new filter was not added correctly. Filter match entries are now accepted regardless of the order in which they are entered into the table.

Patch 86222-25 for Software Release 2.2.2 C613-10319-00 REV X