Allied Telesis 86222-25 manual PCR Module SWI Network affecting No

Patch 86222-25 For Rapier Switches and AR800 Series Modular Switching Routers 31

PCR: 01227 Module: PPP Network affecting: No

If PPPoE AC services were not deleted in the same order they were added, the DELETE command would return an “operation successful” message but the service would still appear in the output of the SHOW PPP PPPOE command. This issue has been resolved.

PCR: 01229 Module: SWI Network affecting: No

The CREATE CONFIG command did not include all required L3FILTER parameters in the generated script file.

PCR: 01232 Module: SWI Network affecting: No

The L3 table on the Rapier G6 is now cleared when a switch port goes down to ensure the L3 and ARP tables are consistent.

PCR: 01234 Module: SWI Network affecting: No

A switch port that was transmitting STP BPDUs and also mirroring its transmit traffic to the mirror port caused a fatal error. This issue has been resolved.

Features in 86222-06

Patch file details for Patch 86222-06 are listed in Table 19.

Table 19: Patch file details for Patch 86222-06.

Base Software Release File	86s-222.rez
Patch Release Date	30-Aug-2001
Compressed Patch File Name	86222-06.paz
Compressed Patch File Size	226776 bytes

Patch 86222-06 includes all issues resolved and enhancements released in previous patches for Software Release 2.2.2, and the following enhancements:

PCR: 01188 Module: SWI Network affecting: No

The power supply voltages of the base board PHYs on a Rapier G6 are controlled by a PHY register value, which was incorrectly set. This issue has been resolved.

PCR: 01190 Module: PIM Network affecting: No

In PIM Dense Mode, if a data stream started before PIM hello messages were exchanged, the receiver did not get the data stream. This issue has been resolved.

PCR: 01192 Module: SWI Network affecting: No

The Rapier G6 base ports sometimes experienced spurious link up or link down events. This issue has been resolved.

Patch 86222-25 for Software Release 2.2.2 C613-10319-00 REV X