AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 181
Configuring the RADIUS Server
To configure the RADIUS client, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type U to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
38.
3. Type R to select RADIUS Server Configuration.
The RADIUS Server Configuration Menu is shown in Figure 49.
Figure 49. RADIUS Server Configuration Menu
4. To set the RADIUS server’s IP address, do the following:
a. Type I to select Set Server IP.
The following prompt is displayed:
Enter IP address for RADIUS server>
b. Type the IP address of the RADIUS server and press Enter.
5. To configure the shared secret, do the following:
AT-9000/24 Local Management System
Basic Switch Configuration -> RADIUS Server Configuration Menu
Server IP Address : 0.0.0.0
Shared Secret :
Response Time : 10 seconds
Maximum Retransmission : 3
----------------------- <COMMAND> -----------------------------
Set Server [I]P
Set Shared Se[c]ret
Set [R]esponse Time
Set [M]ax Retransmission
[Q]uit to previous menu
Command>