Chapter 3: Basic Switch Parameters
44 Section I: Using the Menus Interface
Configuring SNTP
The AT-S84 software is shipped with the client version of the Simple
Network Time Protocol (SNTP). You can configure AT-S84 to obtain the
current time and date from an SNTP or Network Time Protocol (NTP)
server located on your network or on the internet.
SNTP is a reduced version of the NTP. However, the SNTP client software
is interoperable with NTP servers.
To configure SNTP, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration Menu, type T to select Set SNTP
Server IP.
The SNTP Configuration Menu is shown in Figure 8
Figure 8. SNTP Configuration Menu
3. Configure the SNTP server’s IP address:
a. Type P to select Set SNTP Server IP.
AT-9000/24 Local Management System
Basic Switch Configuration -> SNTP Configuration Menu
Time ( HH:MM:SS ) : 00:19:58
Date ( YYYY/MM/DD) : 2006/01/01
SNTP Server IP : Enabled
SNTP Polling Interval : Enabled
Time Zone : GMT (+800:Taipei)
Daylight Saving : Disabled
----------------------- <COMMAND> -----------------------------
Set SNTP Server I[P]
Set SNTP [I]nterval
S[e]t Daylight Saving
Set Time [Z]one
[Q]uit to previous menu
Command>