Installing the Bridging Converter
16
Installing the Bridging Converter
To install an AT-FS238a/x or an AT-FS238b/x Series Bridging Converter,
perform the followin g procedures:
1. Remove all equipment from the package and store the packaging material
in a safe place.
Note
Do not remove the dust cov er from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can adversely
impact the operating performance of the port and the bridging
converter.
2. Attach the four protective feet (provided) to each corner of the bottom of
the unit. Refer to Figure 7. Do not attach the protective feet if you
are installing the bridging converter in an AT-MCR12 chassis.
Figure 7 Attaching the Protec tive Feet
3. Configure the DIP switches. Refer to Figure 2 on page 2 for the location of
the DIP switches and Table5 on page 17 for the possible settings.
Note
Changing the DIP switch settings are effective after resetting the unit.
To reset the unit, power the unit OFF then ON.