AT-FS705LE Installation Guide

Note

For wall-mount installation, you must supply the two screws and plastic anchors or other material necessary to physically mount the switch to the wall.

3.Install two plastic anchors and two pan-head screws into the wall, separated by 5 centimeters (approximately 2 inches).

4.Position the switch onto the wall screws.

5.Plug the power adapter into the power receptacle, then plug the DC power cord into the DC connector on the front panel of the switch.

Warning

The power cord is used as a disconnection device. To de-energize equipment, disconnect the power cord.

5

6.Connect￿the data cables to the ports on the switch.

7.Attach the data cables to the switch ports. Do not use a cross-over cable to connect workstations or servers to ports 1 through 5.15

Page 29
Image 29
Allied Telesis AT-FS705LE manual Connectthe data cables to the ports on the switch