Allied Telesis AT-FS708LE manual Installing the Unit on a Desktop

Installing the Unit on a Desktop

To wall-mount the switch on a wall, refer to “Installing the Unit on a Wall” on page 29.

To install the switch on the desktop, perform the following procedure.

1.Attach the four self-adhesive rubber feet to the bottom of the device, positioning them in the indentations.

2.Place the device on a flat, level surface.

Warning

The power cord is used as a disconnection device. To de-energize equipment, disconnect the power cord.

5

3.Plug the power adapter into a power source and then plug the DC power cord into the DC connector on the front panel of the switch.

4.Make sure the PWR LED on the front panel is green. If the LED is OFF, refer to “Troubleshooting” on page 31.

5.Connect the twisted pair cables to the twisted pair ports on the switch and on the end- nodes.

28