AT-FS708LE Installation Guide
6.Power ON the end-nodes connected to the switch.
7.Check that the LNK/ACT LED for each port on the switch is green. If a LED is OFF, refer to “Troubleshooting” on page 31.
The AT-FS708LE switch is now ready for use.
Installing the Unit on a Wall
For wall-mount installation, you can position the switch vertically or horizontally on the wall using the keyhole cutouts in the bottom of the switch chassis.
Note
For wall-mount installation, you must supply the two screws and plastic anchors or other material necessary to physically mount the switch to the wall.
1.If attached, remove the rubber feet, data cables, and power cord from the switch.
2.Select a wall location for the switch.
3.Install two plastic anchors and two pan-head screws into the wall, separated by 5 centimeters (approximately 2 inches).
