Allied Telesis C613-16164-00 REV E manual Awplusconfig-if#switchportaccess vlanx

		Configuring VRF-lite
CONFIGURING VLANS AND VLAN DATABASE		PURPOSE
Step 1	awplus(config)#vlan database	VLANs are created in the VLAN database, and
		ports are assigned to relevant VLANs.
Step 2	awplus(config-vlan)#vlan x state enable
Step 3	awplus(config-vlan)#exit
Step 4	awplus(config)#interface portx.x.x
Step 5	awplus(config-if)#switchportaccess vlanx
Step 6	awplus(config-if)#exit
CONFIGURING LOCAL LOOPBACK IP INTERFACE		PURPOSE
Step 1	awplus(config-if)#interfacelo1
Step 2	awplus(config-if)#ip address x.x.x.x/x	Optional - IP network is associated with the LO
		interface, to be used by upper layer routing
		protocols.
Step 3	awplus(config-if)#exit
CONFIGURING VLANS - IP AND VRF MEMBERSHIP		PURPOSE
Step 1	awplus(config)#interface <vlan-name>	VRF routing domains are formed by associating
		a VLAN Layer 3 interface with a VRF instance.
Step 2	awplus(config-if)#ip vrf forwarding <vrf-	<name>is the name of a VRF instance created
	name>	by the IP VRF <name> command.
Step 3	awplus(config-if)#ip address <subnet>
Step 4	awplus(config-if)#exit
DYNAMIC ROUTING PROTOCOL - OSPF INSTANCE		PURPOSE
Step 1	awplus(config)#router osfp <1-65535>	Optional. Associate an OSPF routing instance
	<vrf-name>	with a specific VRF instance, and enter router
		configuration mode.
Step 2	awplus(config-router)#network<x.x.x.x/	Define a network on which the OSPF instance
	x> area <area-id>	runs and the area ID for that network.
Step 3	awplus(config-router)#redistribute	Configure the device to redistribute information
	<protocol>	from another routing protocol into OSPF. For
		example BGP can be specified, to allow OSPF
		to advertise inter-VRF routes to an OSPF peer.
Step 4	awplus(config-router)#exit

Page 14 Configure VRF-lite