2 | Patch Release Note |
Features in SB244-03
Patch
PCR: 02414 | Module: IPV6, SWI, IPG, VLAN Network affecting: No |
MLD snooping is now supported on
Series Switches.
PCR: 02451 | Module: IPG, PIM, VLAN, SWI Network affecting: No |
The following issues have been resolved:
•PIM was disabled when the RESET IP command was executed.
•PIM reverse path check was not working correctly.
•PIM_DM assert was not working correctly.
•DVMRP messages were not being flooded correctly.
•Executing the SHOW PPP command sometimes caused a fatal error.
•IP forwarding was not working correctly on SwitchBlade 4000 Series Switches.
•Changes have been made for supporting
PCR: 02471 | Module: IPG | Network affecting: No |
The counter for transmitted ARP packets was incorrect. This issue has been resolved.
PCR: 02480 | Module: SWI | Network affecting: No |
On SwitchBlade 4000 Series Switches, the MIB browser could not see the slave controller card. This issue has been resolved.
PCR: 02483 | Module: SWI, TM | Network affecting: No |
When SwitchBlade 4000 Series Switches were operating with a full set of line cards, and the test module was enabled for all interfaces, an excessive amount of traffic was generated. This issue has been resolved.
PCR: 02486 | Module: SWI | Network affecting: No |
VLAN number 4077 could not be created. This issue has been resolved.
PCR: 02487 | Module: SWI | Network affecting: No |
When there were 4000 VLANs, executing the DESTROY VLAN=ALL command caused a fatal error. This issue has been resolved.
PCR: 02490 | Module: IPv6 | Network affecting: No |
The ADD IPV6 ND command was not displayed by the SHOW
CONFIGURATION DYNAMIC command. This issue has been resolved.
PCR: 02491 | Module: IPG | Network affecting: No |
The ARP cache is now updated when a gratuitous ARP request or reply packet is received.
Patch
