Allied Telesis SB244-03 manual Errata, Availability

8 Patch Release Note

PCR: 02415 Module: IPG Network affecting: No

Packets with a RIP source address and next hop address that are not on the same subnet as the interface will now be processed. If the received next hop is not on the same subnet, it is treated as 0.0.0.0.

PCR: 02420 Module: SWI Network affecting: No

On GBICs, the link was forced up when the transmit fibre was removed. Once up, the link could not be taken down again by removing the transmit fibre. This issue has been resolved.

PCR: 02423 Module: SWI Network affecting: No

IGMP messages sometimes caused a fatal error. This issue has been resolved.

PCR: 02425 Module: IPG Network affecting: No

Multicast downstream groups are now added and deleted correctly.

Errata

AT-9800 Series Switches do not have Ethernet interfaces (for example, eth0). Previously released documentation incorrectly states that these interface types are valid. AT-9800 switch ports are Ethernet ports, and these are referenced in commands with the PORT parameter.

IPSec and ISAKMP are not available on the 2.4.4 release for SwitchBlade 4000

Series Switches and AT-9800 Series Switches.

Availability

Patches can be downloaded from the Software Updates area of the Allied Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html. A licence or password is not required to use a patch.

Patch SB244-03 for Software Release 2.4.4 C613-10349-00 REV C