Allied Telesis SB244-03 manual Support for multi-homed interfaces has been added

Patch SB244-03 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 5

PCR: 02460 Module: SWINetwork affecting: No

Sometimes a port reported an interface as being down, but the port counters kept incrementing. This issue has been resolved.

PCR: 02461 Module: SWINetwork affecting: No

The CREATE TRIGGER MODULE=SWITCH command now recognises ports in x.y notation when specifying the PORT parameter.

PCR: 02462 Module: SWINetwork affecting: No

A fatal error occurred on SwitchBlade 4000 Series Switches when booting from a script that added ports to a trunk group that was hot swapped out. This issue has been resolved.

PCR: 02463 Module: DVMRP, IPG Network affecting: No

Support for multi-homed interfaces has been added.

PCR: 02467 Module: CORE Network affecting: No

The board descriptions have changed for some instances of AT-9800 Series

Switches.

PCR: 02468 Module: SWI Network affecting: No

When a Telnet session was closed, SWITCH debug was not disabled if it had been enabled for the Telnet session. This issue has been resolved.

PCR: 02469 Module: TM Network affecting: No

After an ASYN port test, the port is now reset to its pre-test state if the test was started by a user connected to the same ASYN port.

PCR: 02470 Module: SWI Network affecting: No

The Built-in Self Test failed on SwitchBlade chassis. This issue has been resolved.

PCR: 02476 Module: VRRP, CORE Network affecting: No

The configuration was not restored correctly after a line card was hot swapped out. This issue has been resolved.

PCR: 02478 Module: SCRIPT Network affecting: No

A string compare error was occurring in the conditional statement of the script. This issue has been resolved.

Patch SB244-03 for Software Release 2.4.4 C613-10349-00 REV C