Allied Telesis SB251-10 Features in SB251-06, Features in SB251-05, Module SWI, SYSR, Level

6 Patch Release Note

•The PORT parameter of the SET STP PORT command specifies either all the ports in a trunk group, or none of the ports in a trunk group.

•The STPFORWARD parameter has been added to the ENABLE SWITCH and DISABLE SWITCH commands. If STPFORWARD is enabled, and there is no enabled STP instance, then the switch will forward all received BPDUs. If STPFORWARD is enabled, and an STP instance is enabled, then STPFORWARD will be disabled by default and a message will be generated.

•The SHOW SWITCH command now shows the status of the BPDU Forwarding feature.

PCR: 03401 Module: SWI

An enhancement has been made to the Test module to optimise the reception of the loopbacked packets that are used to confirm operation of the switch ports.

Features in SB251-06

Patch file details are listed in Table 5.

Table 5: Patch file details for Patch SB251-06.

Base Software Release File	sb-251.rez
Patch Release Date	10-Apr-2003
Compressed Patch File Name	sb251-07.paz
Compressed Patch File Size	79684 bytes

Patch SB251-06 includes all issues resolved and enhancements released in previous patches for Software Release 2.5.1, and the following enhancements:

PCR: 03340 Module: SWI, SYSR Level: 1

After a power cycle, or a reboot command, the SwitchBlade would occasionally repeatedly restart if it had two active controller cards. Also, the Slave controller card would sometimes not take over if the Master controller card failed.

Features in SB251-05

Patch file details are listed in Table 6.

Table 6: Patch file details for Patch SB251-05.

Base Software Release File	sb-251.rez
Patch Release Date	31-Mar-2003
Compressed Patch File Name	sb251-05.paz
Compressed Patch File Size	71096 bytes

Patch SB251-10 for Software Release 2.5.1 C613-10361-00 REV J