Allstar Products Group 3500-P, J3500 Testing the All-Clear Photosystem, Security Switch is Garage

F:OPERATION AND ADJUSTMENT INSTRUCTIONS

A DAMAGED OR MALFUNCTIONING PHOTOELECTRIC ACCESSORY SYSTEM COULD ENABLE A GARAGE DOOR TO CLOSE ON PEOPLE OR PROPERTY, CAUSING SERIOUS INJURY OR DEATH. PERFORM THIS TEST MONTHLY TO ENSURE YOUR ALL-CLEARIS WORKING PROPERLY.

STEP 5: Testing the All-Clear™ Photosystem —

Start the door in the close travel direction and then place an obstacle approximately 8" high by 12" wide in the path of the beam. The Red Pilot Light on the Allstar Access All-Clear™ Photosystem should go out. The door should stop and reverse to the full open position.

With the door fully open and at rest, place the obstacle in the path of the beam once again. Activate the Standard Wall Push Button. The opener should revert to and remain in the PUSH AND HOLD mode of operation for close travel.

IF THE GARAGE DOOR TRAVELS MORE THAN ONE INCH IN A DOWNWARD PATH AFTER RELEASING THE BUTTON, THE ALL-CLEAR™

IS MALFUNCTIONING. CHECK THE ELECTRICAL CONNECTIONS AND ALIGNMENT OF THE ALL-CLEAR™.

104393

STEP 6: Operating the Deluxe Wall Station Controls — The Deluxe Wall Station replaces standard doorbell-type pushbuttons to allow you to integrate fully with all the convenience and security features built into your Allstar 3000 Series garage door operator.

1.Operator Pushbutton — Red-backlighting. Used to start or stop the operator. The function of this pushbutton is automatically

104394	Operator Pushbutton	disabled when the Security slide switch is set to the “ON” position and the door is
		fully closed.

Security Switch

Operator Light Push button

2.Operator Light Pushbutton —Yellow-backlighting. Turns the operator light on and off, but does not activate the door operator. The operator light will stay on until turned off using this pushbutton, or until door operation is initiated, which overrides the function of this pushbutton and automatically turns the light off after 4-1/2 minutes.

3.Security Switch — Prevents unwanted door operation from pushbutton, key switches, keyless entry systems, radio controls, etc. When the Security Switch is moved to the “ON” position, with the garage door fully closed, signals from all of these devices are locked out by the operator. Such devices will continue to work until the door is fully closed, allowing you to set the switch (when leaving on vacation, for example), leave the garage and close the door remotely.

THE SECURITY SWITCH IS GARAGE.)

(NOTE: YOU WILL NOT BE ABLE TO OPEN YOUR GARAGE DOOR USING RADIO CONTROLS OR EXTERIOR ACCESS CONTROLS UNTIL RETURNED TO THE “OFF” POSITION. THIS MUST BE DONE FROM INSIDE THE

When the Security Switch is engaged, the red light behind the Operator Pushbutton is extinguished as an indication. The Operator Light Pushbutton will continue to function normally.

19