6-EN
Getting Started
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
•The unit can be turned on by pressing any other button except eject
c, TITLE.
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1Turn off the unit power.
2Press RESET with a ball-point pen or similar
pointed object.
Setting Time
1Press MENU to select SETUP.
2Press g or f to select the CLOCK mode.
3Turn the Rotary encoder to adjust the hours.
4When the hour has been adjusted, press the
Rotary encoder.
5Turn the Rotary encoder to adjust the minutes.
6When the minute has been adjusted, press the
Rotary encoder.
7When the setting has been completed, press
MENU to select RETURN.
The unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
•
To synchronize the clock to another clock/watch or radio time
announcement, press and hold the Rotary encoder for at least 2
seconds after setting the “hour.” Minutes will reset to 00. If the
display shows over “30” minutes when you do this, the time will
advance one hour.
•If no operation is performed in 60 seconds, the unit returns to
normal mode.
SOURCE/
POWER MUTE
Opening and Closing the Movable Display
Press c.
The movable display will open.
To close the movable display, press c again.
The movable display will close.
•Do not apply shock to the movable display when it is open as it
may result in malfunction of the unit.
•The display may be dim during low temperatures and immediately
after turning on the power. The brightness will return to normal as
time elapses.
•The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Display Tilt Adjustment
The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
1Press MENU to select the TILT mode.
2Turn the Rotary encoder to adjust the tilt angle of
the movable display.
3Press MENU to select RETURN.
The display returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
•The display will close a half minute after the ignition key is turned
to the OFF position.
•The adjusted tilt angle of the display is stored in memory. There is
no need to re-adjust the tilt angle when the power is turned back on
.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
RESET
Rotary
encoder
cMENUg f
Movable display